The cheapest way to fence a garden combines a low-cost perimeter material — hardware cloth, chicken wire, or no-dig metal barrier panels — with ground-level sealing that actually stops burrowing animals without requiring professional installation.

Most budget garden fencing fails not because the material is cheap, but because it skips the ground gap. Rabbits and small animals don't push through a fence — they go under it. A no-dig metal barrier panel like Kyate's Laokuan series, pushed 8–9 inches below ground and cable-tied to an existing fence, closes that gap without renting equipment or buying concrete. At 17 inches per panel, 14 panels cover 20 feet of fence line — more coverage per panel than 12-inch standard alternatives.

  • Kyate Laokuan 14-panel set covers 20 linear feet of fence line at 17 inches per panel.
  • No-dig barrier panels install 8–9 inches below ground — no post-hole digger or concrete required.
  • Kyate Tight Gap series runs a 1.2-inch grid gap, narrower than the 1.55-inch standard that juvenile rabbits can squeeze through.
  • Every Kyate barrier set includes cable ties, gloves, and wire cutters — no separate hardware store trip needed.
  • Kyate cable-tie panel connections are reusable — cut, remove, and reinstall at a different location next season.

Step-by-Step

  1. Measure your fence line: Walk the full perimeter and record linear footage, adding 2–3 extra feet for corners — they always consume more panel length than the straight-line measurement suggests.
  2. Select the right panel set: Divide your fence line footage by 1.42 (feet per Kyate Laokuan panel) to get panel count, then round up to the next available set size — 14, 30, or 46 panels.
  3. Probe the soil for rocks: Push a screwdriver or thin stake along the fence line before installing panels — locate buried rocks now and clear them manually so panels don't buckle mid-installation.
  4. Push panels into the ground: Using the included gloves, drive each Kyate Laokuan panel into the soil until 8–9 inches sit below ground level — use a rubber mallet on hard soil, never a metal hammer directly on the wire grid.
  5. Connect panels with cable ties: Overlap adjacent Kyate panels by one grid square at each joint and thread the included cable ties through both layers — pull tight with the included cutting plier and trim the excess tail flush.
  6. Attach the top edge to your existing fence: Run additional cable ties through the top row of the Kyate panel and into the existing fence structure every 12–18 inches — this prevents the panel from leaning outward under animal pressure.
  7. Check for ground gaps: Walk the full installed run and press the panel flat against the soil surface — any visible gap wider than 1 inch at ground level needs a handful of compacted soil pressed against the base to seal it.